Innomed Cardio-Aid 200-B Dual Capacitor Assembly
130-0257-002 UP1-16920J 100μF 2100VDC
► Innomed Cardio-Aid 200-B Dual Capacitor Assembly 130-0257-002 UP1-16920J 100μF 2100VDC Introduction
Innomed Cardio-Aid 200-B Dual Capacitor Assembly 130-0257-002 UP1-16920J 100μF 2100VDC allows for rapid charging and discharging of energy, facilitating effective delivery of shocks during emergency situations.
► Replacing the HV Capacitor
WARNING! Before handling the high-voltage capacitor, ensure it is de-energized by measuring it with a voltage probe (1000:1). When connecting the high-voltage probe, be careful not to touch the terminals and use adequate insulation. If voltage is present, wait until the high-voltage capacitor is completely discharged. If the capacitor is still charged, you can discharge it by connecting a drain resistor (e.g., 100 kΩ, 17 W) directly across the high-voltage capacitor terminals for at least 30 seconds. Be careful when connecting the resistor and use adequate insulation.
1. IMPORTANT! When storing the high-voltage capacitor, always short-circuit it.
1. Place the Cardio-Aid® chassis in the closed service position, on the right side of the rear chassis.
2. To remove the high-voltage capacitor, cut the two cable ties holding it in place.
IMPORTANT! Note the location of the cable ties for correct reassembly.
2. Remove the high-voltage capacitor.
4. Remove the high-voltage (HV) capacitor plates, observing their polarity.
5. Remove the shorting wire from the new high-voltage capacitor.
6. Install the high-voltage capacitor plates into the HV-C. WARNING! Ensure the polarity of the high-voltage capacitor plates is correct.
7. Remove the protective tape from the high-voltage capacitors and secure them to the chassis.
8. Install the cable ties on the high-voltage capacitors. Reassemble in reverse order.
IMPORTANT! The cable ties securing the high-voltage capacitors must be securely tightened to ensure mechanical stability.
► Specification of Innomed Cardio-Aid 200-B Dual Capacitor Assembly 130-0257-002 UP1-16920J 100μF 2100VDC
| Product Name | Innomed Cardio-Aid 200-B Dual Capacitor Assembly 130-0257-002 UP1-16920J 100μF 2100VDC |
| Brand | Innomed |
| Part no | 130-0257-002 |
| Compatible With | Innomed Cardio-Aid 200-B Defibrillator |
| MOQ | One piece |
| Warranty | 90 days |
► Photo of Innomed Cardio-Aid 200-B Dual Capacitor Assembly 130-0257-002 UP1-16920J 100μF 2100VDC
Thank you so much for your attention.If you're interested in Innomed Cardio-Aid 200-B Dual Capacitor Assembly 130-0257-002 UP1-16920J 100μF 2100VDC ,feel free to contact us .Thank you .
Product Tags:
|
|
Innomed Cardio-Aid 200-B Dual Capacitor Assembly 130-0257-002 UP1-16920J 100μF 2100VDC Images
|
